Serial port eprom programmer11/30/2022 The software is GUI based - does not require long command lines.This programmer is also not universal, but in some cases it works on chips, where the more expensive fail. The software comparability - for some specific chip is difficult to find the proper software.There are a lot of different programmers on the market, but all of them have some limitations: How to use the programmer is described also there. There the programmer must be defined as "SI Prog I/O". In the linked site is given the list of all supported chips. The microcontroller must be supplied and a cable connection to the VC terminal of the programmer and the 5V power supply of the microcontroller must be established.Īs supporting software for the programmer can be used the Ponyprog. Now with an ICSP header Comes with ICSP cable. It doesn't have supply voltage to be used to power the microcontroller. It supports 8, 18, 28 and 40 pin PIC microcontrollers which allow serial programming and I2C EEPROM memories. It can be used if the computer has "real" RS232 port (+15V/-15V). It has a cable interface corresponding the Arduino one. 3.3 or 5 V operation (3.3 V only on serial port) Supports the series 24Cxxx, 25Cxxx and 93Cxxx from different manufacturers (e.g.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |